StarTouch™ Replacement Straw Set - Mint to Be

• Sensory Bumps: Provides a tactile guide for baby’s lip rounding and closure at the straw tip.

• Short Straw: The short straw design reaches only to the baby’s tongue tip, supporting tongue tip elevation and development of a mature swallow pattern.

• EasyDrink Valve: Allows for easy, spill-free sipping without hard suction or biting.

• Gravity Ball Straw: Drink from any angle even as your little one tilts or inverts the cup.

• Compatible with SofTouch™ Nursing Bottles (240ml/300ml/330ml) : Turn your existing SofTouch™ Bottles into a straw bottle by using the StarTouch™ Adapter and Straw Set. This replacement straw set has a longer straw length that can be paired with the bottles.

• Creating a Baby-Friendly World: More sustainably made with 20%ISCC-Certified Bio-Based Plastic* thus reducing reliance on non-renewable virgin plastics.

*For the Connector only, mass balance approach.

^This is a replacement straw set for StarTouch Straw Cup Adaptor, StarTouch cup is sold separately.

**New SofTouch™ BPP Nursing Bottles only (PP/PPSU/T-Ester). Do not use StarTouch™ Adaptor on Glass Bottles.

Before first use, disassemble the product and clean thoroughly. Then, place all components in boiling water for 5 minutes. This is to ensure hygiene. Always wash your hands with soap before cleaning, sterilizing and feeding.

For safety and hygiene reasons, The straw top may be worn by biting. Special attention is needed for teething child. Replace the Straw Set when you observe signs of wear tear to maintain optimal condition of the Straw.

After each use: Wash thoroughly with sponge brush to wash cups and adaptor. You may use Pigeon Cleansing Foam Spray to wash the straw and cup, and SofTouch™ Straw Brush for Gravity Ball Straw to wash the Gravity Ball Straw.

Ensure that all parts including areas which may not be visible are thoroughly washed and rinsed to remove any liquid residues. 

StarTouch™ Replacement Straw Set - Mint to Be:

• Straw
• Straw Connector
• Gravity Ball Straw

In order to use the replacement straw, the StarTouch™ Adapter is required to pair it to your choice of SofTouch™ Nursing Bottles OR StarTouch™ Cup.

How to clean:
Be sure to sterilize before every use.
Boiling Sterilization: Place all parts in boiling water for 5 minutes.
Steam Sterilization: You can use Pigeon Steam Sterilizer and follow the directions in the user manual.

UV' Sterilization is possible. Chemical Sterilization is possible for al parts except the Gravity Sall Straw.
Use sterilization products made specifically for baby bottles and nipples. Follow the instructions in the user's manual for these products. With chemical sterilization, the printing on the bottle may fade.

Caution:
It is recommended to replace the product when it starts to discolour and/ or turn cloudy.

• Do NOT sterilize or heat the Gravity Ball Straw in a microwave oven.
• After boiling sterilization, the bottle will be hot. Be careful not to burn yourself.
• All grease or oil residue should be thoroughly removed before sterilising to avoid permanent staining of parts.

• Avoid putting hot or carbonated liquids in the cup. The air pressure inside the cup will Increase and leakages might occur from the tip of the straw.
• Avoid putting hot liquids in the cup as they may cause burns.
• Open and close the lid firmly. Improper handling of lid may cause leakages.

For safety and hygiene reasons, replace the Straw Top and Gravity Ball Straw every 2 months.